We stock a wide selection of petrol taps and fuel tank parts for Urals motorcycles.
We cover most models from the 1970s right through to the latest Ural motorcycles.
This site only shows a small fraction of our spares stock.
We cover most models from the 1970s right through to the latest Ural motorcycles.
This site only shows a small fraction of our spares stock.
F2 Motorcycles Ltd
290 Leverington Common
Wisbech, Cambridgshire
PE13 5JG
Workshop Open
9.00am - 5.00pm Tues - Sat
Phone 01945 410165
2.00pm - 5.00pm Tues - Sat
VAT Number GB 715 2467 43
290 Leverington Common
Wisbech, Cambridgshire
PE13 5JG
Workshop Open
9.00am - 5.00pm Tues - Sat
Phone 01945 410165
2.00pm - 5.00pm Tues - Sat
VAT Number GB 715 2467 43
F23004/KP15 - KP15 tap
Price each - £42.00
Original fitment for Ural 650 M63, M66, M67. Also Dnepr MT9, MT10/36 and MT11. 14mm male thread with twin output. These taps have very weak threads.
When fitting a replacement we advise coating the threads with a sealer and screwing the tap in by hand. Applying large forces with a spanner will snap the threaded part off the tap.
When fitting a replacement we advise coating the threads with a sealer and screwing the tap in by hand. Applying large forces with a spanner will snap the threaded part off the tap.
F23004/15ALT - ALT 15 tap
Price each - £30.00
Price each - £30.00
The KP15 tap is original fitment for Ural 650 M63, M66, M67. Also Dnepr MT9, MT10/36 and MT11. It is often impossible to obtain originals so we offer an alternative.
This alternative has a single outlet so we supply it with a T-piece.
F23004/33ALT - ALT33 tap
Price each - £60.00
From roughly 1999 to about 2003 Ural used a tap known as the KP33A tap. It screwed onto some male threads on the tank and can be identified by the oval plate behind the on/off lever which was attached with two screws.
Original KP33 taps are no longer available, BUT we have an alternative single outlet tap with the correct threads for a Ural, supplied complete with T-piece.
Original KP33 taps are no longer available, BUT we have an alternative single outlet tap with the correct threads for a Ural, supplied complete with T-piece.
F23004/33ALT - ALT33twin
Price each - £39.60
From roughly 1999 to about 2003 Ural used a tap known as the KP33A tap. It screwed onto some male threads on the tank and can be identified by the oval plate behind the on/off lever which was attached with two screws.
Original KP33 taps are no longer available, BUT we have an alternative twin outlet tap supplied with an adaptor to fit the Ural tank.
Original KP33 taps are no longer available, BUT we have an alternative twin outlet tap supplied with an adaptor to fit the Ural tank.
F23004/VAC - VAC tap
Price each - £90.00
Price each - £90.00
Standard fitment to most later 750 Urals. Attached to the tank with two M6 screws. Opened by vacuum from the carburetors when the engine is running. This is the factory supplied original tap with single outlet. You can usually reuse your T-piece, but we do stock them if you need one.
F23004/NO - No VAC tap
Price each - £42.00
Price each - £42.00
Direct replacement for the vacuum tap and attached in the same way. Not opened by vacuum so you need to remember to turn fuel on and more importantly off again. Good quality lower cost alternative to the expensive vacuum tap. Note this has two 6 mm outlets so if you are converting from vacuum type tap you will require more fuel hose.
F23004/CJ - Chang Jiang 750 Tap
Price each - £24.00
Price each - £24.00
Fits Chang Jiang 750 M1, M1M and M1S with the M16 x 1.00 pitch threaded boss sticking out of the bottom of the tank. Tap itself has left hand thread so as the nut is tightened it draws the tap up hard against the tank thread.
F23004/FT - Ferry Tap
Price each - £15.00
Top quality inline all metal stop tap. If you have a Ural fitted with a standard vacuum tap we strongly advise fitting and using one of these between the vacuum tap and the carburetors for long term storage or while the bike is being transported either by road or ferry. Vacuum taps have tiny diaphragms in them that shut the fuel off, unfortunately vibration can allow this to leak slightly so over a few hours on a ferry they can leak enough to fill the engine with fuel.
F23013 - Viton Pipe
Price 50 cm - £13.20
Price 100 cm - £24.00
Genuine Viton, flexible fuel pipe. This is the only fuel pipe that is 100% petrol, diesel, ethanol and E10 proof. We now have this in two bore sizes 5.5 mm and 7.3 mm. Please specify when ordering. We supply this in both 50 cm and 100 cm lengths.
F23013/FIL - Fuel Filter
Price each - £15.00
Screw together high quality in line fuel filter with bronze micro-porous filter, can be cleaned and re-used. keeps your carbs clean.
F23018 - Viton Seals
Price each - £12.00
Viton Tank Cap Seals. Viton is 100% petrol, diesel, ethanol, biofuel and E10 proof. Available in 3 sizes.
BSA bantam/A10/M20 etc
60mm x 45mm x 1.5mm
Jawa/CZ
79mm x 62mm x 4mm
Ural/Dnepr
86mm x 63mm x 3mm
F23013/CONN - Connector
Price each - £18.00
If you have ever removed the fuel tank from a Dnepr or Ural you will know how frustrating the balance pipe is. The tank needs to be completely drained and then there is still fuel left in the pipe. This clever connector fits in the balance pipe and when it is pulled apart to remove the tank both sides seal.
F23002/LOC - Petrol Cap
Price each - £72.00
Price each - £72.00
Standard screw in locking petrol cap fitted to most Urals from about 2000 onwards. We have them in chromes or black.
F23002/NOL - Petrol Cap
Price each - £30.00
Non locking alternative to the screw in petrol cap. Black only.
F23002/CAP - Large Cap
Price each - No Stock
Fits most Dnepr (Dnieper) motorbikes including MT9, MT10/36 and MT11. Also fits Ural M63, M66, M67 and some later 650/750s. Supplied with seal. Nice original quality cap, not the thin brittle ones from ebay.
F23017 - Petrol Baffle
Price each - £30.00
This fits all Dneprs and Urals originally fitted with the large tank cap and acts as a baffle when you brake so the tank cap leaks a lot less.
This site uses Google Analytics
© F2 Motorcycles Ltd.
© F2 Motorcycles Ltd.